10.0 k

Show Description
Close Description

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power.

It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Show Specs
Close Specs
FeaturesVoltage10.0kw
Output Power (RMS)4 ohm14.4V3,000Wx1
2 ohm14.4V5,500x1
1 ohm14.4V10,000Wx1
1 ohm16VN/A
1 ohm18VN/A
Input Sensitivity 6V~0.2V
Low Pass FilterSwitchable
( @ 24 dB Slope)VariableHz35~250
Subsonic FilterSwitchable
( @ 24 dB Slope)VariableHz10~50
Bass BoostVariabledB0-9dB
Frequency Response Hz15-270
Signal to Noise Ratio dB100
Damping factor 150<
Efficiency @ 4ohm %Over 90%
THD @ 4ohmsLess than 0.1%
Fuse Rating1,000 Amps
Linked Fuse Rating2,000 Amps
IndicatorPowerYes
ProtectionYes
Clip No
Speaker & Power terminalMold Type Yes
PowerGauge0Ga x 3
Heatsink Length37.0" (940mm)
Heatsink Length11.5" (292mm)
Heatsink Length2.6" (66mm)

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Triple 0 awg power and ground inputs

We recommend for installation

• 1 upgraded battery under the hood

• 3 extra 800ci battery in the rear

• Minimum of two 0 awg ran from the front battery to the rear battery

• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp

• 2 Upgraded aftermarket alternators

• Dash mounted voltage meter

Wc Car Audio
Droppin Hz
Sky High
Audio Intensity
SSA Audio
Showtime Electronics
Sonics Electronics
© DC Audio 2016